Tuning the carburetor - the car works properly

To make tuning of the carburettor by own strength it is possible. With what to begin? First of all, we look under the diffusers of the main metering systems, since on throttle valves there may be an unnecessary object. For example, the screw lying in the carburetor gets into the cylinder, and this can lead to engine failure.

After that, we unscrew the solenoid valve, while removing the idler from it, clear it and see if the valve works.tuning carburetorDo not forget to check the gap of coldstroke and integrity of the diaphragm of the entire cold start. We pay great attention to the float. It should not touch the wall of the float chamber. Freewheel and level adjustment is achieved by bending the corresponding tabs. And thanks to our own language, we check the tightness of the check valve. Carefully screw the solenoid valve, as it can damage the thread. Lubricate the O-ring with oil, this will help feel the touch of the idle jet of its seat in the main cover.adjustment of the carburetor sollex

We check tuning of carburetor Solex:

  • Nuts, so they are well attached.
  • The action of the gas pedal drive (in the event thatfully press it, then the throttle should take a vertical position). This is regulated by the gas cable fixing nut, leaving the drive free running, and in the 2nd chamber we pour a little gasoline and wait about 20 seconds. During this time, the gasoline should remain, if it disappeared, then we look at the adjusting screw of the second chamber.
  • The work of the accelerator pump. Gasoline from the sprayers should appear immediately after the throttle valve is opened. If this does not happen, then to solve the problem, look at the accelerator drive eccentric or lever.

tuning carburetor sollexThen unscrew the air jets in assembly withemulsion tubes, as well as fuel jets under them. With the help of a toothpick, we get fuel jets from the wells by unscrewing the cap of the economizer of the power regimes (do not forget about the spring) to check the integrity of the cleanliness of the jet and the diaphragm.

After all, we clean the tuning of the carburetor andcollect, only in reverse order. Cleaning is done by air. Try to blow carefully so that not a single mote remains. During the connection of the suction cable, you need to check and adjust its action. This setting carburetor Solex assumes without fail. If the suction handle is pushed in, the air flap of the carburettor should take a vertical position.

Tuning the carburetor-this is one of the stages of complex engine repair. He many times improves his work. In principle, this process is not so complicated. But, nevertheless, it is necessary to produce it often enough. At the same time, the main thing is that the Solex carburetor setting is done on time.

Car tuning can be performed by any car enthusiast, and you do not need any special knowledge, just basic skills will suffice.

Related news

Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly Tuning the carburetor - the car works properly